Welcome! Log In Create A New Profile

Orca Slicer

Posted by Darathy

Darathy

Orca Slicer
March 24, 2024 04:30PM

Registered: 10 years ago
Posts: 638

Hello ,
i just revived my Ormerod 2 after few years of it lying in a corner and i am wondering ,anyone still using Ormerod 2 and configured Orca slicer for it? if so can you post the configuration for it? i want to try it ,but seems a bit complicated for me,

Reply Quote

dc42

Re: Orca Slicer
March 25, 2024 03:35AM

Registered: 11 years ago
Posts: 14,688

You may get more responses if you post this at [forum.duet3d.com].

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Reply Quote

Gar1

Re: Orca Slicer
October 10, 2025 09:59AM

Registered: 5 weeks ago
Posts: 1

Quote
Darathy
Hello ,
i just revived my Ormerod 2 after few years of it lying in a corner and i am wondering ,anyone still using Ormerod 2 and configured Orca slicer for it? if so can you post the configuration for it? i want to try it ,but seems a bit complicated for me,

I know the possibility of getting your reply is really low, but, have you find the configuration? Can you share with me if yes?
Thanks