Hi All,
I just got myself a prusa mendel V2 and really enjoying the build and configuration. This is my 5th test print and was wondering if you guys have a suggestion to lessen the webbing when it comes from going to one point to another in this case it was around 70mm apart. When it comes to the part where it bolts on to the bar it is almost no webbing. It happens when it is further. I was looking at the head and i see about 1mm of material dripping. I tried to make is slower on the travel but it made it worst.
I am using printrboar which i also calibrated the extruder settings.
Head - 185
Bed - 60
I have attached my slicer settings.
Thanks so much!