Hi everyone.
I need a little help with my electronics/software setup.
I finished building my mendel Prism a few weeks ago and up untill the last weekend everything was going fine but now when I do a long print or multiple prints one after another, my printer eventualy stops printing in the middle of a print with no apparent reason and wont respond in pronterface. It even crashed after only printing for 15 minutes but only once.
To get it going again I have to disconnect/reconnect the usb cable and restart pronterface.
I'm using RAMPS 1.4 electronics with an up to date Pronterface and Marlin firmware.
Any idea whats going on?
ps.: I also seem to be unable to leave the printer plugged in for a long time without using it. When I come back after leaving it plugged in doing nothing, overnight for example, it doesn't respond to pronterface. So I end up power cycling the printer every time I want to use it.
Edited 2 time(s). Last edit at 09/10/2012 10:14PM by thecrazy.