Welcome! Log In Create A New Profile

Problem with height

Posted by Howarto

Howarto

Problem with height
September 15, 2012 07:25PM

Registered: 11 years ago
Posts: 5

Hi, I have a problem with my printer... The problem is that the height of the figure is lower than the real piece.

In the cube of calibration of 20x20x10 I have 9'3mm of height.

I use Marlin + CURA

Someone has this problem?

Reply Quote

Polygonhell

Re: Problem with height
September 15, 2012 07:43PM

Registered: 12 years ago
Posts: 939

Either it's calibrated incorrectly, i.e. wrong number of steps/mm in the firmware, or you're missing steps when Z moves.
What steps/mm do you currently have for Z? and what's the hardware, what size threaded rod, micro-stepping etc?