Welcome!
Log In
Create A New Profile
Home
>
Reprappers
> Topic
Advanced
Problem with height
Posted by
Howarto
Forum List
Message List
New Topic
Howarto
Problem with height
September 15, 2012 07:25PM
Registered: 11 years ago
Posts: 5
Hi, I have a problem with my printer... The problem is that the height of the figure is lower than the real piece.
In the cube of calibration of 20x20x10 I have 9'3mm of height.
I use Marlin + CURA
Someone has this problem?
Reply
Quote
Polygonhell
Re: Problem with height
September 15, 2012 07:43PM
Registered: 12 years ago
Posts: 939
Either it's calibrated incorrectly, i.e. wrong number of steps/mm in the firmware, or you're missing steps when Z moves.
What steps/mm do you currently have for Z? and what's the hardware, what size threaded rod, micro-stepping etc?
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login