I'm trying to setup my RAMPS board but I'm having some trouble
Running the RAMPSTestCode from
here give's this error:
avrdude: stk500v2_getsync(): timeout communicating with programmer
When I look at the serial console i get this over and over again:
echo:enqueing "G0 E10 F3000"
echo:enqueing "T1"
echo:Active Extruder: 1
ok
echo:enqueing "G0 E0 F3000"
echo:enqueing "G90"
ok
echo:enqueing "G0 X10 F3000"
echo:enqueing "G0 Y10 F3000"
echo:enqueing "G0 Z2 F3000"
echo:enqueing "T0"
echo:Active Extruder: 0
ok
and looks like this:
Edited 1 time(s). Last edit at 10/22/2013 11:27PM by yanofsky.