Hello,
i built a Rostock Delta Printer over the last few weeks but now i have a few problems at calibration.
My first problem is the height at the Z tower.
When i calibrate the Rostock properly and then adjust the Home Position in x or y (not z) the calibration screws totally up.
My second problem is the alignment of the effector platform, when i move the head in one of the corners the whole platform tilts.
I have a RepRap Rostock with Traxxas Rods and i use Marlin Firmware.
Kind Regrads,
Marcus
Edited 2 time(s). Last edit at 01/21/2014 02:03PM by marli.