ramps not working November 20, 2014 04:02PM |
Registered: 9 years ago Posts: 18 |
Re: ramps not working November 20, 2014 04:06PM |
Registered: 9 years ago Posts: 74 |
Re: ramps not working November 20, 2014 04:23PM |
Registered: 9 years ago Posts: 18 |
Re: ramps not working November 21, 2014 12:23AM |
Registered: 11 years ago Posts: 1,592 |
Re: ramps not working November 21, 2014 02:20AM |
Registered: 9 years ago Posts: 18 |
Re: ramps not working November 21, 2014 04:24AM |
Registered: 9 years ago Posts: 8 |
Re: ramps not working November 21, 2014 04:44AM |
Registered: 9 years ago Posts: 18 |
Re: ramps not working November 21, 2014 04:58AM |
Registered: 9 years ago Posts: 1,011 |
Re: ramps not working November 21, 2014 05:22AM |
Registered: 9 years ago Posts: 8 |
Quote
Stalker
that is exactly the same. What potentiometr are you talking about ? The one thats on the LCD board ? And if so is it the biger one or the smaller one that has to be adjusted with a screw driver ?
Re: ramps not working November 22, 2014 02:32AM |
Registered: 11 years ago Posts: 1,592 |
Re: ramps not working November 23, 2014 12:47PM |
Registered: 9 years ago Posts: 8 |
Re: ramps not working November 24, 2014 03:02AM |
Registered: 11 years ago Posts: 17 |
Re: ramps not working November 24, 2014 12:12PM |
Registered: 9 years ago Posts: 18 |
Re: ramps not working November 24, 2014 12:26PM |
Registered: 10 years ago Posts: 477 |
Quote
Stalker
Hi guys I found time to get back to my printer and it turned out that the problem was the power supply. Now i mannaged to move all the motors but the problem is that when i conect it to pronterface it moves only one way and i can not make them move the other all the motors are conected exactly the same way and only y axis moves both ways. Another thing is that some motors stop moving and start to vibrate once in a while and then continue to move freely. Any ideas ?
Re: ramps not working November 25, 2014 04:32AM |
Registered: 9 years ago Posts: 8 |
Quote
Stalker
Hi guys I found time to get back to my printer and it turned out that the problem was the power supply. Now i mannaged to move all the motors but the problem is that when i conect it to pronterface it moves only one way and i can not make them move the other all the motors are conected exactly the same way and only y axis moves both ways. Another thing is that some motors stop moving and start to vibrate once in a while and then continue to move freely. Any ideas ?
Re: ramps not working November 27, 2014 02:07PM |
Registered: 9 years ago Posts: 18 |