Heated bed question January 12, 2015 09:07PM |
Registered: 12 years ago Posts: 15 |
Re: Heated bed question January 13, 2015 12:19AM |
Registered: 9 years ago Posts: 36 |
Quote
PedroB
Hi all,
I have sucessfully (so far) built a Prusa i3 from scratch. About 4 months of picking away at it. Printed my first parts this past weekend.
2 basic questions: it seem that it takes a very long for the bed to heat up. over 25min to get up to 120 deg C. I have 16awg wires going to the bed. Thermister poking up through the little hole.
What should I be looking for to troubleshoot this?
also: using Pronterface and Slic3r. When I'm printing a part, is there a way to see the g-code execute line by line? another part of the question: after I generate the g-code with slic3r how can i get a look at entirety of the code.( i.e. what can I use to open up the file to see the individual line of code?)
Thanks to all who post here, I have learned a lot by just browsing through the many posts.
Cheers,
Peter
Re: Heated bed question January 13, 2015 03:02AM |
Registered: 9 years ago Posts: 329 |
Re: Heated bed question January 13, 2015 04:24AM |
Registered: 9 years ago Posts: 1,011 |