Motor Temperatures

I understand the motors that come in the Folger kits are smaller than a lot of others meaning they have to work harder? I'm on my first extended print now and am noticing that my X axis motor is quite warm. It starts to get uncomfortable if you keep your fingertips on it for ten seconds or so although I don't think it would burn you. What's a "bad" temperature for these motors? Is there way way to cool them other than the obvious sticking a fan on them?

I had the same problem with mine. It never caused me a failed print, but I didn't want to take a chance. I'm not sure what a safe temperature is, but it was effing hot. I just printed a fan bracket (Bracket on thingiverse and bought a fan. They had 40mm fans at my local tinkering shop for 47 cents! Couldn't pass it up. Ever since, it has stayed cool to the touch.