Stepper Motor Extension Cable

Does anyone have a good sounce for extension cables for Nema 17 stepper motors? I have made some on my last project, but would be nice to just get them if they sell them cheap some place.

Quote
AquaticsLive
Does anyone have a good sounce for extension cables for Nema 17 stepper motors? I have made some on my last project, but would be nice to just get them if they sell them cheap some place.

Use this.... [www.amazon.com]
They worked just fine for me

Thanks, going to look for the 4 pin cable ends to make it a little more solid.

Ive been looking atmaking anew loom.
I needed to find the plugs for the motors.
Maybe my topic in the motor section will help a little.
[forums.reprap.org]

Gordon

---

Gordon
Currently have a tweaked mendel prusa i2
About to build a P3Steel.
[scratchpad.thisandthose.org]

Printer for hire.
[www.3dhubs.com]

Member of South London Makerspace:
[southlondonmakerspace.org]

Thanks Gordon.

I will check it out.

I ended up ordering these LINK

Lipo balance extension leads

You might want to read that thread as you may have ordered the 2.5mm rather than 2mm pitch connectors.
I ened up with the JST-PH6 rather than the 2.5mm pitch JST-XH youve ordered.

[forums.reprap.org]

I went through 2 other sets of connectors before csambrook put me right after doing some research for me.
That im very grateful for.


Gordon

---

Gordon
Currently have a tweaked mendel prusa i2
About to build a P3Steel.
[scratchpad.thisandthose.org]

Printer for hire.
[www.3dhubs.com]

Member of South London Makerspace:
[southlondonmakerspace.org]