I'm trying to test that my HotEnd and Bed controls in Pronterface
Heat is set to 230, I then press "Set"
T:26.4/230.0 B:108.8/0.0 T0:26.4/230.0
Unless I'm misunderstanding this
T:26.4 should be rising until it reaches 230.0 - Correct?
Instead of T - 'B' is rising
I double checked and the Hotend is connected to D10 on the Ramps and the Bed is on D8
What could cause this?
Attachments:
open |
download -
2016-03-17 21_39_14-Clipboard.jpg
(45.2 KB)