Dimensional Weird One April 09, 2016 08:40AM |
Registered: 8 years ago Posts: 34 |
Re: Dimensional Weird One April 10, 2016 01:28AM |
Registered: 9 years ago Posts: 705 |
Re: Dimensional Weird One April 10, 2016 08:13AM |
Registered: 11 years ago Posts: 5,780 |
Re: Dimensional Weird One April 10, 2016 09:49AM |
Registered: 8 years ago Posts: 34 |
Quote
the_digital_dentist
1mm is too close to the bed- the plastic distorts from the heat. Calibration measurements should generally be done at least a few mm above the bed.
It is critically important to do a complete calibration of the extruder before you try to calibrate the X and Y axes. Did you use the actual diameter of the filament when you sliced or use an extrusion multiplier based on a test print?
Re: Dimensional Weird One April 10, 2016 10:32AM |
Registered: 11 years ago Posts: 5,780 |