Hi,
im just putting on a new z probe on my printer and everything went fine so far except that its inversed.
The probe is wired for NC and so
const bool Z_MIN_PROBE_ENDSTOP_INVERTING = false; // set to true to invert the logic of the endstop.
this should be the right setting and the probe reacts to pressing the button by changing its state however it showed up as triggered when the button isnt pushed.
So I switched the probe inverting to true but it doesnt change anything. its staying in reverse no matter if i define it true or false.
any ideas?
P.S
all my other endstops are wired NO. I did that a long time ago and never changed it but I cant imagine that interfering.