Controlling RAMPS from the computer April 27, 2016 12:29AM |
Registered: 8 years ago Posts: 1 |
Re: Controlling RAMPS from the computer April 27, 2016 01:30AM |
Registered: 9 years ago Posts: 483 |
Re: Controlling RAMPS from the computer April 27, 2016 05:32AM |
Registered: 9 years ago Posts: 978 |
Re: Controlling RAMPS from the computer April 27, 2016 05:54AM |
Registered: 8 years ago Posts: 260 |
Re: Controlling RAMPS from the computer April 27, 2016 02:07PM |
Registered: 12 years ago Posts: 1,236 |
Re: Controlling RAMPS from the computer April 27, 2016 02:36PM |
Registered: 11 years ago Posts: 1,049 |
Quote
ramuyko
I'd like to know if there's an opensource software that communicates directly with the RAMPS board (or any other 3D printer driver) without using the arduino... So the gcode is interpreted in the computer while it receives the signals from the thermistors and send the control for the drivers (probably via USB, serial port, parallel port...)
Has anyone ever heard about controlling a RepRap this way?