I am converting a CubeX Trio to Reprap and I need help programming the Marlin Firmware to work with my setup. I'm new to arduino and I am only able to get 1 hot end programmed with no errors. I am also getting a min temp error?
I have attached the code I modified but so far have had no success. Any help would be greatly appreciated.
Here are the following details I would like to program in Marlin.
Controller Board: Azteeg X3 V1.1
LCD: Viki Lcd
Heated Bed: Yes
Extruders: 2 (Dual Head with 2 E3D V6 Hotends)
Auto Bed Leveling: Inductive Proximity Sensor LJ12A3-4-Z/BX (Z-Axis)
End Stops: Analogue X and Y Axis
X-Axis Motors: 1
Y-Axis Motors: 2
Z-Axis Motors: 1
Fans: 2 Extruder Fans, 2 Filament Fans
Led Strips: 1 Extruder, 1 Case
