Teacup vs Sprinter

When I get back off of this business trip I think I'm going to try switching firmware on my Gen6 Mendel. Can anyone comment on the relative pro's and con's of Teacup vs. Sprinter? I've heard a lot about both, but not sure which to switch too.

Also, any experiences getting either up and running on Gen6 hardware?

Thanks,

James

---

--
Check out my blog: AdventuresIn3-DPrinting

Teacup is (still) more technologically advanced, while Sprinter is said to have this "it just works" feature.

---

Generation 7 Electronics	Teacup Firmware	RepRap DIY

Has anyone shifts during printing on Sprinter? Teacup working stable.

Teacup shines on smaller memory footprint arduinos.

Sprinter's best on RAMPS.

Each has benefits. Personally, Sprinter "Just Works" for me.