Upgrading only Prusa i3 to MKS sbase 1.3 July 14, 2018 05:04AM |
Registered: 5 years ago Posts: 4 |
Re: Upgrading only Prusa i3 to MKS sbase 1.3 July 14, 2018 09:48AM |
Registered: 8 years ago Posts: 5,232 |
Re: Upgrading only Prusa i3 to MKS sbase 1.3 July 14, 2018 07:05PM |
Registered: 5 years ago Posts: 4 |
Re: Upgrading only Prusa i3 to MKS sbase 1.3 July 14, 2018 07:34PM |
Registered: 6 years ago Posts: 1,863 |
Quote
robotix83
Have noticed that you can also get 24v 50w heater cartridges now, will these be compatible with the board without damaging it? [www.ebay.com.au]
Re: Upgrading only Prusa i3 to MKS sbase 1.3 July 15, 2018 11:40AM |
Registered: 6 years ago Posts: 1,007 |
Re: Upgrading only Prusa i3 to MKS sbase 1.3 July 16, 2018 02:49AM |
Registered: 8 years ago Posts: 5,232 |
Re: Upgrading only Prusa i3 to MKS sbase 1.3 July 16, 2018 04:45AM |
Registered: 6 years ago Posts: 1,007 |
Quote
o_lampe
Quote
MKSA
Going to 24V will speed up the bed heating.
I doubt it will be noticeable. At least when you have sufficient wires for 12V.