Welcome! Log In Create A New Profile

Putting X-axis wrong way

Posted by Vuokko

Vuokko

Putting X-axis wrong way
May 17, 2016 02:45PM

Registered: 8 years ago
Posts: 68

I needed some space between X axis and frame for extruder on my P3steel and I ended up turning x-axis 180 degrees. Now X rods aren't between Z rods and frame and Z can go higher.

What kind problems I have created for myself? Except motor rotates wrong way and I can just flip the connector.

Reply Quote

gforce1

Re: Putting X-axis wrong way
May 17, 2016 04:33PM

Registered: 10 years ago
Posts: 344

If you mean by flipping 180 degrees around that the motor is now on the other side then it is no problem. Just flip the connector. Replace your endtop on the original side.