ramps 1.4 smoking when heating the bed August 25, 2017 12:52AM |
Registered: 6 years ago Posts: 34 |
Re: ramps 1.4 smoking when heating the bed August 25, 2017 03:04AM |
Admin Registered: 13 years ago Posts: 7,013 |
Re: ramps 1.4 smoking when heating the bed August 25, 2017 06:16AM |
Registered: 6 years ago Posts: 34 |
Re: ramps 1.4 smoking when heating the bed August 25, 2017 08:22AM |
Registered: 6 years ago Posts: 1,869 |
Re: ramps 1.4 smoking when heating the bed August 26, 2017 03:39AM |
Registered: 7 years ago Posts: 103 |
Re: ramps 1.4 smoking when heating the bed August 26, 2017 04:24AM |
Registered: 6 years ago Posts: 34 |
Quote
slippyr4
I'd personally not bother with ramps at all. The MKS GEN and MKS base are much better boards, with an extra mosfet you can use for another extruder or a fan and the bed mosfet ar capable of enough amps. They cost about the same as a budget ramps clone and budget arduino mega clone together. And are pin/firmware compatible with ramps.
Re: ramps 1.4 smoking when heating the bed August 26, 2017 04:39AM |
Registered: 7 years ago Posts: 103 |
Quote
vfwfw
I have been looking at that board and wondering if it was any better. Do the same A4988 stepper drivers fit the MKS board?
Re: ramps 1.4 smoking when heating the bed August 26, 2017 09:06AM |
Registered: 6 years ago Posts: 34 |