Welcome! Log In Create A New Profile

Marlin halt while fast printting

Posted by beebrain

beebrain

Marlin halt while fast printting
July 25, 2016 12:21PM

Registered: 7 years ago
Posts: 5

Hi I make 3d print with Ramp1.4 and Marlin firmware.
Marlin is powerful and I found a problem when I try to set speed print to 120% or more than sometimes my 3d print is halt , I can't take action it example push the reset button or kill button.
when marlin halts I saw green led blink. and i know led is status for communication between pc and marlin but I print form SD card I unplug usb port.

How to solve it ??

Reply Quote

BICUtech

Re: Marlin halt while fast printting
October 11, 2016 10:43AM

Registered: 7 years ago
Posts: 17

It could be the ramps board overheating, ive had this problem before, do you have a fan blowing on the stepper motor drivers?, if not that could be the issue, the led indicator i believe turns on wherever the board recieves input, and the display will output the gcode to the arduino, that couldbe why its flashing