Autolevel G29
April 11, 2017 05:56PM
Hello Goodnight.

I have a question from this G29 instruction.

I have an inductive sensor and everything works ok, Marlin Rc2.

Perform the offset of Z from Eprom with M206 z1.0 .... or M206 z1.1

I see that the autolevel works properly only when the hot bed has a set slope of 0.1 but my engines are capable of making 0.05 moves.

Where can I see the configuration of this part in Marlin?

Best regards.
Re: Autolevel G29
April 12, 2017 12:03AM
RC-2 is so old I don't even remember it. Please cross your settings over to RC-8's RCBugFix. I think you will feel it was worth the effort.
Sorry, only registered users may post in this forum.

Click here to login