Slight Pause in my Printing
June 27, 2017 05:21AM
Hi Guys
I have upgraded my firmware to the latest Marlin firmware to my Prusa i3.

While printing there is a slight ( split second ) pause to my printing.
I have changed the Jerk from 20.00 down to 5.00 and no change. Not sure whats causing the printing to do that slight pause during my prints. It seems to be when it changes LINES, not even when it increases height. I tried printing from SDcard & USB.

Any suggestions would be appreciate it,

Re: Slight Pause in my Printing
June 27, 2017 11:56AM
I changed the USB cable and it did the same thing.
I then changed from Simplify3D to Slic3r and there is no pause in the print. So it must be the slicer program - Simplify 3D

Any suggestions

Edited 1 time(s). Last edit at 06/27/2017 04:06PM by scubi.
Sorry, only registered users may post in this forum.

Click here to login