Welcome! Log In Create A New Profile


1.1.8, UBL, CR-10S, and filament sensor

Posted by xeddog 
1.1.8, UBL, CR-10S, and filament sensor
January 31, 2018 08:54PM
I have a Creality CR-10S and I have installed the EZABL system on it. I have been trying to implement Unified Bed Levelling using Marlin 1.1.8 on it but I am having a problem. The filament sensor is ALWAYS triggered, so the printer is useless. I have been going over and over the configuration files trying to find out what is going on, but no joy. If I rework the config files for BiLinear levelling it works just fine. BiLinear also works with Marlin 1.1.6 and 1.1.7, so there isn't a problem with the sensor. Any ideas what I should be looking for to fix this?


Sorry, only registered users may post in this forum.

Click here to login