Welcome! Log In Create A New Profile

Filament out after first layer

Sacramento

Filament out after first layer
July 03, 2018 05:59AM

Registered: 6 years ago
Posts: 8

Hi everybody

I'm having a problem with Marlin 1.1.9.
I start printing and everything goes ok, but after the first layer extruder goes to the back of the printer and takes out all the filament and then noozle and bed temperatura goes down and cannot continuing print.

I would like some help on this as I cannot fix the problem.

Thanks in advance
Sacramento

Reply Quote

Dust

Re: Filament out after first layer
July 03, 2018 06:05AM

Admin
Registered: 13 years ago
Posts: 7,002

post the first two layers of gcode

they we can check if the printer is just doing as its told or something else

Reply Quote

Roberts_Clif

Re: Filament out after first layer
July 03, 2018 09:45AM

Registered: 6 years ago
Posts: 1,863

Quote
Sacramento
Hi everybody

I'm having a problem with Marlin 1.1.9.

Thanks in advance
Sacramento

Hello can't find Marlin 1.1.9
[marlinfw.org]

Computer Programmer / Electronics Technician

Reply Quote

Sacramento

Re: Filament out after first layer
July 03, 2018 12:10PM

Registered: 6 years ago
Posts: 8

Hi Dust

Enclosed the Gcode of raft layers where the problem starts. It does the first layer and then goes to the back and completly get the filament out.

I checked that already and could not find anything wrong. Pls check it and give me feedback

Thanks and regards
Sacramento

Edited 1 time(s). Last edit at 07/03/2018 12:13PM by Sacramento.