TMC2130 not functioning - Ramps 1.6
July 29, 2018 12:23PM

I'm using the TMC2130 with senseless homing combined with a Ramps 1.6 on Marlin 1.1.x Bugfix.
I installed an SD-Cardreader and an LCD so I had to reconfigured some pins. (based on this instruction)

When I power up the borad, the motors doen't move, I can easily move them by hand.

Everything should be wired correctly
I attached my configuration and the output of the M122 Command.

Maybe someone can help me with this.

Thanks Syncnaptic
open | download - Configuration.h (69.1 KB)
open | download - Configuration_adv.h (68.4 KB)
open | download - pins_RAMPS.h (15.3 KB)
open | download - M122.txt (1.4 KB)
Re: TMC2130 not functioning - Ramps 1.6
August 08, 2018 06:25PM
I will read throu your configs tomorow, but:
DO NOT MOVE YOUR MOTORS the tmc2130s are uch mor sensible thats why watterott sells the tmc protection boards, i burned a new x axis driver last week just by "homing from hand"
Sorry, only registered users may post in this forum.

Click here to login