Back off endstops after homing
Posted by RFZ
|
Back off endstops after homing September 21, 2018 03:26AM |
Hi,
is there a way to configure marlin to back off the endstops by about ~5mm after homing (all axis)? I'm used to repetier and it has this feature but I couldn't find it on marlin...
Thx
is there a way to configure marlin to back off the endstops by about ~5mm after homing (all axis)? I'm used to repetier and it has this feature but I couldn't find it on marlin...
Thx
Sorry, only registered users may post in this forum.