Hello.
It may be the already mentioned topic, but I am operating a multi-extruder with a single nozzle.
At the time of printing, the inactive step motor (E) doesn't hold and is free, but can we change the setting to hold?
Because the active E movement pushes back the inactive E filament, I want to stop it.

Printer : Kossel Delta / Diamond Hotend / Marlin-1.1.8-bugifx

Edited 1 time(s). Last edit at 10/18/2018 11:36AM by yoch.

Should i run M84 S0?

M84 S0 was valid only for XYZ.

I found a simple solution.
I realized that sharing the stepper driver's enable pin is a good thing.