Welcome! Log In Create A New Profile

Advanced

Cannot do Z probe calibration

Posted by _ranzo 
Cannot do Z probe calibration
September 27, 2019 04:13PM
Just got a Modix Big 60 V2 printer, put it together,

Trying to do the calibration.

Stuck at the probe calibration,

I am not able to move the z axis up but can only move it down.

Anyone has the same problem? (does not have to be the same machine I guess?)

Marlin Version 1.1.9B

Thanks.
Re: Cannot do Z probe calibration
September 28, 2019 08:02AM
I would Check the Z-Axis End-Stop Switch / sensor using M119.
It sounds like it is not functioning correctly could be a broken wire or could be plugged in incorrectly.


Electronics Technician / Computer Programmer
Sorry, only registered users may post in this forum.

Click here to login