Hello everyone. I'm trying to auto-level my printer and I'm wondering to how to adjust the proximity of the nozzle to the surface? I'm using an inductive probe. Do I adjust the nozzle proximity, for printing the first layer, by adjusting the probe height manually or do I do it in the firmware some how? I tried changing Z_PROBE_OFFSET_FROM_EXTRUDER but it doesn't seem to do anything.
I manually adjusted the height of the probe from the nozzle so that the nozzle is supper close when probing. I was thinking that if I got the nozzle as close as possible that I could fine tune it in the firmware.
Please advise. Thanks.
Edited 1 time(s). Last edit at 01/15/2020 02:38AM by CVRIV.
