I am very happy with Marlin 2.0.3, however I have just discovered my E stepper motor is not shutting off at the end of the print.
At the end of each print I have the filament retract 8mm and the push the bed forward , turn off the fans, then turnoff the steppers ( M84). X Y and Z are now free to move and cool down while the E stepper stays locked and stays hot. I have added M18 to the end script but it still stays on and hot. If I press the reset button it will release the E stepper and it will begin cooling. Using a RAMPS 1.4 board. What have I done wrong?
Edited 2 time(s). Last edit at 02/15/2020 05:12PM by waynert3d.