Hi All,

Having a bit of an issue when trying to use the z stepper auto align feature.

Recently upgraded to Marlin 2.x to be able to use this feature as found my z steppers would usually get out of sync. (Not using Z endstops, just a probe)

When I try to activate the feature via Motion > Auto Z-Align the carriage moves to its first far left position and probes fine. But when moving to its far right position, it gets to the centre point of the bed (X=138) and probes there instead.

I've fiddled around a bit with the bed size offsets but can't seem to get it to behave. I've attached Conf.h and Conf_adv.h files for anyone to have a look if they'd be so kind.

Thanks

Preddy

Edited 1 time(s). Last edit at 08/16/2020 03:33PM by Preddy.