Welcome! Log In Create A New Profile

Advanced

After Resume Z is too close to printed model

Posted by Burak 
Forum List Message List New Topic
Burak
After Resume Z is too close to printed model
September 26, 2021 05:09AM
Hello,

I start to print something then I pause it and after I resume it is too close to printed model how can I increase z after resume?

I tried to increase

#define POWER_LOSS_MIN_Z_CHANGE 0.05

//#define POWER_LOSS_ZRAISE 2 (I do not have ups)

but none of them work. any suggestions?

Thanks,
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login