So I'm very new to this. I've been tinkering for about 6 months with my printer and I've fitted a few things such as a 3dtouch, everything was working and I decided upgrade firmware but it ruined my prints and I didn't have a backup of the firmware that was on it which was printing ok. So I thought I'd go the full hog and up it to 1.1.9 but now my 3dtouch has stopped working correctly.
When I use the home function it does the X and Y fine, but when homing the Z it doesn't raise the axis before deploying the probe. I can't figure out what I've done wrong. If I start to home from a raised position it seems to work for the first probing and lowers to the bed with the probe extended and stops when the bed touches it but when it goes to do the second probe the Z axis doesn't raise and just deploys against the bed and the probe turns red! I can't figure it out, I've been staring at the code for hours to no avail. Any help would be amazing!
Edited 2 time(s). Last edit at 10/14/2021 07:52AM by Metalgearslug.
