Could do with some help in getting my Duet board working over USB [RESOLVED] February 01, 2017 03:35PM |
Registered: 9 years ago Posts: 893 |
Re: Could do with some help in getting my Duet board working over USB February 01, 2017 04:51PM |
Registered: 10 years ago Posts: 14,672 |
Re: Could do with some help in getting my Duet board working over USB February 01, 2017 05:11PM |
Registered: 9 years ago Posts: 893 |
Re: Could do with some help in getting my Duet board working over USB February 02, 2017 04:48AM |
Registered: 10 years ago Posts: 14,672 |
Re: Could do with some help in getting my Duet board working over USB February 02, 2017 05:08AM |
Registered: 9 years ago Posts: 893 |
Re: Could do with some help in getting my Duet board working over USB February 02, 2017 05:28AM |
Registered: 10 years ago Posts: 14,672 |
Re: Could do with some help in getting my Duet board working over USB February 02, 2017 08:31AM |
Registered: 9 years ago Posts: 893 |
Re: Could do with some help in getting my Duet board working over USB February 02, 2017 10:03AM |
Registered: 9 years ago Posts: 893 |
Re: Could do with some help in getting my Duet board working over USB February 02, 2017 11:33AM |
Registered: 10 years ago Posts: 14,672 |
Quote
David J
The only thing that still sounds a bit clunky is when it's printing the 3-row skirt around the part - I have no idea why, as when it gets to the part itself it prints smoothly. I'm not going to stress about it though...
Re: Could do with some help in getting my Duet board working over USB February 02, 2017 01:32PM |
Registered: 9 years ago Posts: 893 |
Quote
dc42
That probably means that the skirt has some rather abrupt angles in it instead of smooth curves. Reducing the jerk setting in the firmware will make it sound better; but if you set it too low then curves will print slowly.