Tool 1 was not driven because its heater temperatures were not high enough or it has a heater fault January 20, 2020 01:20AM |
Registered: 4 years ago Posts: 2 |
Re: Tool 1 was not driven because its heater temperatures were not high enough or it has a heater fault January 20, 2020 02:52PM |
Registered: 10 years ago Posts: 14,672 |
Re: Tool 1 was not driven because its heater temperatures were not high enough or it has a heater fault January 20, 2020 10:53PM |
Registered: 4 years ago Posts: 2 |
Re: Tool 1 was not driven because its heater temperatures were not high enough or it has a heater fault January 21, 2020 01:44AM |
Registered: 10 years ago Posts: 14,672 |
Re: Tool 1 was not driven because its heater temperatures were not high enough or it has a heater fault January 21, 2020 03:42PM |
Registered: 7 years ago Posts: 619 |
Quote
htrabbit
it did not fault, the Cura slicer issued a T0 S0 in the gcode. it decided that it did not need T0 anymore and shut the heater off. 1 heater and 2 extruders has always been a problem for these slicers. I just need a way to catch it.
in no way did the Duet fail, it did what it was told.
I just need it to react differently, I need it to pause rather than keep going without extrusion.