Support for M581 & M582 in dc42 fork

When looking at G-code RepRapWiki [reprap.org] I see that these commands have partial support in dc42's fork. However when I try to execute them I get invalid code message. There is also no mention of these codes in source code. I have installed out of filament sensors on extruder's endstops but cannot see any other way of using them to pause print when filament runs out. Any idea what is going on?

---

Reality is in fact virtual.

I am still in the process of implementing M581 and M582.

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

David, any ETA on these? Please, don't take it the wrong way. It's just that it would be nice to know when we can expect these.

---

Reality is in fact virtual.

Quote
yoorek
David, any ETA on these? Please, don't take it the wrong way. It's just that it would be nice to know when we can expect these.

Hard to say because of Duet NG firmware work, but possibly 1-2 weeks from now.

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].