Welcome! Log In Create A New Profile

hot end heater connection on duet v6

Posted by appjaws1

appjaws1

hot end heater connection on duet v6
June 02, 2016 05:59AM

Registered: 10 years ago
Posts: 780

Is it safe just to use the 2 middle pins for the hot end + and - connection or should I link the two negative pins and link the two positive pins?

appjaws - Core XYUV Duet Ethernet Duex5
firmware 3.1.1 Web Interface 3.1.1
Ormerod 1-converted to laser engraver, Duet wifi
OpenSCAD version 2020.07
slic3r-1.3.0, Simplify3D 4.1.2, Cura-4.4.1

Reply Quote

dc42

Re: hot end heater connection on duet v6
June 02, 2016 06:26AM

Registered: 10 years ago
Posts: 14,672

Yes if you are using a 24V heater. If you are using a 12V heater then I recommend you use all 4 pins.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].