I have an issues I was hoping someone could help with.
I have just installed an E3DV6 hotend on my printer with a Duet 0.8 board. In the config I have:
M305 P1 T100000 B4388 R4700 H0 L0
On the web interface I am seeing a temperature of 168C as soon as the printer turns on. I have tried tweaking the T value all the way down to T1000 and at T1000 I get room temperature(or close to it) to read. When I tell the heater to activate though, the temperature reading never changes. It will heat all the way to 170 and start melting my PLA without so much as a degree change in the temperature reading.
Any ideas what I am doing wrong?