Thanks For Your Fast Response KingRahl Following the video response works like a charm. Thanks Again!by BelowYet - Sanguino(lolu)
Since the diferance was the teeth from 8 to 18 teeth It was for Fact my settings. The measurements of the travel between the X,Y,Z needed to be Recalculated and flashed from the arduino software to the bootloader holding sprinter in my sanguino 1.3a board. that sure made a difference in the print The steps are not to dificult for anybody to follow. Example is at: Also A Prusa Calculator at:by BelowYet - Reprappers
I'm having problems. I'm printing oval pulley gears instead of circle pulley gears! I'm trying to print CIRCLE Pulleys I never had this problem until I went from a 8tooth pulley to a 18tooth pulley for BOTH X and Y on my reprap But, this only started right after I purchased the "---->T2.5 Aluminum Timing Pulley 18T + Timing Belt 3m for RepRap<-----". So, Originally I had ABS Plastic pulleby BelowYet - Sanguino(lolu)
Hello Everyone. I'm having the same problem. I'm printing oval pulley gears unstead of circle pulley gears! I never had this problem until I went from a 8tooth pulley to a 18tooth pulley for BOTH X and Y on my reprap But, this only started right after I purchased the "---->T2.5 Aluminum Timing Pulley 18T + Timing Belt 3m for RepRap<-----". So, Originally I had ABS Plastic pulleys withby BelowYet - Reprappers
Hello, what is the temperature for this hot end with 1.75mm ABS plastic described BELOW? Reason is I'm new but, I can not get the ABS Plastic hot enough it seems. I Don't know what temp it's suppose to be at. The temp its at now is 230 I figured might have to be up more It melts but won't go fast enough through nozzle then plastic BREAKS and gets hung up in the hobbed bolt My Setup is below>by BelowYet - General