I know on the Rambo 1.3 board to hook up an atx remotely it is pin 4 but where is pin 4 on the board, the schematics mean nothing to me, was easy on a ramps board but not so on the ramboby stefi01 - General
I am getting the same problem, I have marlin on both my printers. ver 1.0.1, uploads fine, this version I tried on IDE 1.6.0 and up, on 2 versions they will verify, the others above 1.6 will say about third party text, none will upload, RC 7 wont even verifyby stefi01 - RAMPS Electronics
i had large ripples on all my prints, changed the motor, belt and drive wheel, tighten the belt, loosened it, no difference, changed the travel time in marlin, changed filtrate, all had no affect what so ever, then i came across this suddenly everything changed after i tried it, i added rubber washers to the motor mount, also added small non slip furniture pads under the printer feet and the ripby stefi01 - General
Quoteleadinglights The ripple problem is one that has been plagueing me as well. The first thing I would note is that the ripples that jbernardis is suffering from is not edge ringing - or at least not simple edge ringing as it does not attenuate. It could be an oscillation that starts at an edge, but is more akin to running a finger across the surface of a balloon. I think that an element of stiby stefi01 - General