Thanks. I will try that. Makes sense. Quotejamesdanielv replace thermal couple with one that settings match your printer firmware. make sure to verify its calibration with an external thermometer if possible. stringiness will always happen a little bit, but if it is not controlled, and stringing even below 160 deg c, then it might be an error with sensor readings. you might have an uncalibrateby shearder - General
Quotedc42 What filament material are you printing with? PLA. 2 different brands. I'm going to design a direct extruder carriage for this printer and testby shearder - General
Quotedc42 When you say: Quote2. Adjusted temps from 220 down to zero extrusion temp How low have you gone? Until the extruder can no longer extrude? Bear in mind that your hot end temperature readings may not be accurate.. Gone down from 235 (tonight) down to zero extrusion. Yes there is temp measurement discrepancy as much as 10% that I've seenby shearder - General
Quotedc42 You say you've tried everything else Also the reason I mentioned this is that people put in a lot of effort at times to help and then post links etc etc etc only with someonentonsay oh i tried that. It was a courtesy more than anything else.by shearder - General
QuoteNumber_5 How dry are you getting your filaments before printing? I am in an area with very low humidity. Have been for many years and printing fine fienthe last 8by shearder - General
Quotedc42 ...you've made it clear that you don't want advice, ..... Nope but what I did say is that i have tried all the usual methods meaning all one would normally do and 99.9% of the links go to the same methods. What I am asking, based on what I said, was something other than what I will post below. Which is why I was asking if microstepoing would cause it. I.e. skipped steps which would beby shearder - General
First PLEASE don't send me links on how to fix retraction and stringing I have done it all and takes minutes to fix! BUT...... I Still have stringing and have applied ALL my knowledge over the last 8 years and that which i have applied to my other printers. This printer is a new build using an MKS Base 1.4 for the first time. I have done EVERYTHING including new nozzles new hotends new bowdeby shearder - General
Ah ok so I need some custom script to run in that space?by shearder - Prusa i3 and variants
I can get the servo working and the command to autolevel but no.matter what the servo does not swing down or move at all when invoke autolevel. I've given up. Staying with manual lol no time for crapby shearder - Prusa i3 and variants
Ok so all was correct in terms of pins etc. I didn't turn on feature servo with a 1. I have the servo working now. G29 doesn't work. I guess G32? Ok I'm still in bed and thinking lolby shearder - Prusa i3 and variants
Hi all So I eventually decided to go back to autoleveling but with a servo version now. I havr a Tevo Tarantula with mks base 1.4 board. I am using the left servo port when viewed with power connectors at the bottom. I am using repetier firmware. I have tried the latest and the dev version. The leveling command works but the servo is not actuated. I have tried test commands M340 and M280 and otby shearder - Prusa i3 and variants
HI all I am looking for mods for the RapMan 3.2 - I know this is RepRap but i am hoping someone can assist. so i am thinking of goinbg to Alu extrusion for the frame and ball screw etc. Any ideas or links? Thanks.by shearder - General