Victor, we are talking here about consumer 3D printers, not about lasers etc. I understand that bigger more powerful heaters exist lol. My heater is 20mmx6mm tube that works perfectly fine with stock Duet board without requiring extra MOS. Not talking about some oversized setups that are heavy. My printer does 300mm/s with perfect quality, because the whole carriage is extremely light.by VladCronos - Plastic Extruder Working Group
I don't think it is at all possible to reach 500C in 10 seconds, unless you are powered by uraniumby VladCronos - Plastic Extruder Working Group
Hello everyone, Would be interesting to hear what is your hotend heat up times. 1. 25-200 2. 25-350 3. 25-500 (if applicable) Here is my data: 1. 20s 2. 35s 3. 50s I really want to know what industry average is and what is considered standard. Thank you in advance for participating in my pollby VladCronos - Plastic Extruder Working Group
Okay, calculator is not helping at all. It is 500C thermistor and I think reprap calc thinks I entered the wrong value, while I didn't. See screenshot attached. Any ideas?by VladCronos - Duet
Thanks a lot. Going to try this. I only have B parameter and Temperature points values. And it keeps reporting 50C at room temperature and about 30C off at high temps.by VladCronos - Duet
Hi folks! I am relatively new to this firmware and I have Duet WiFi board with web client. My company have recently produced a custom new thermistor for 3D printer. I have a PDF here and a task to make it properly work in the firmware, but I have no clue where to start. i went into config file, and found some values there, also looked through the wiki already. Does not help much in my situationby VladCronos - Duet
Hi folks! I am relatively new to this firmware and I have Duet WiFi board with web client. My company have recently produced a custom new thermistor for 3D printer. I have a PDF here and a task to make it properly work in the firmware, but I have no clue where to start. i went into config file, and found some values there, also looked through the wiki already. Does not help much in my situatioby VladCronos - Duet