Show all posts by user
(RepRap en Français)
Page 1 of 1 Pages: 1
Results 1 — 9 of 9
Salut a toi,
Personnellement je me suis offert un RepRap Ormerod2 et j'en suis vraiment content.
Je n'avais aucune expérience ni des CNC, ni de la modélisation 3D...bref un gros newbie
Pour le prix, c'est 520€ mais il faut aimer bricoler car elle est en kit. (j'ai quand même passé pas mal de temps pour la monter et la notice est en anglais)
Le gros avantage selon moi est que lorsque que tu l
by
balak59
-
RepRap Groupe d'Utilisateurs Francophone
Of course after several tests, i need to type this command line after turning off my printer.
Is there a way to write this command line when i turn on the printer ?
by
balak59
-
Ormerod
Quotedc42
That's the correct homeall.g file for an Ormerod 2. So I suggest you check the Y motor loom. By this, I mean check that the order of the coloured wires going into the connector at each and is the same as for the X or Z motor loom.
PS - if the loom is faulty and you don't want to correct it, you can reverse the direction with a command in config.g. I think the command you need is M569 P
by
balak59
-
Ormerod
Exactly the same loom in the same order for both axis.
There is no swapped wires...
Tell me if you want somes photos or video...
I don't know what to do.
by
balak59
-
Ormerod
Any reaction ?
I am lost. Where is the "Home" position of the bed ?
is it on the microswitch or in the other side ?
by
balak59
-
Ormerod
G91
G1 Z5 F200
G1 X20 F2000
G90
G92 Y0
G1 Y-250 F2000 S1
G92 Y0
G1 Y3 F200
G1 Y-30 F200 S1
G92 Y0
G1 Y3 F500 ; adjust the Y value to put the nozzle on the edge of the bed
G92 Y0
G91
G1 X-20 F2000
G1 Z-5 F200
G90
And Voila.
by
balak59
-
Ormerod
OK, It's confirmed, When i prees on Y+the bed move to the left and to the right with the Y- button.
So let's check the loom.
I am a bit septic about the loom. I will try to use the Ormerod control interface (web browser) to see if there is the same problem.
by
balak59
-
Ormerod
Thanks for the fast answer
I checked all of the files on my SD card and even erase it all to create an other SD card from scratch.
Same problem.
I will turn off the printer and checked if there is a swapped wire into the loom.
One question : In the Pronterface software, when i use the job Y+ , the bed must go toward the microswitch or forward ?
Thanks
by
balak59
-
Ormerod
Hi,
I just finish to build my Ormerod 2 and i started to do the "Commissioning part".
Here is my problem :
I'm triying to homing my axis... X & Z seems to be good but when i prees the "home Y" button on Pronterface, the bed run in the wrong direction (forward the microswitch...)
Is it normal ?
I already checked the wire of the y drive and the wire on the Duet board...
Can you help me
by
balak59
-
Ormerod