hello, thank , I got a problem I can't find the board melzi ver 2 1284p in merlin after loading the arduino and merlin. What can I do ?by kkwong1951 - Controllers
thank, after I load merlin I go to tool board to find the configuration.h as attach. Is that the correct configuration.h ? I try to open other configuration.h file it show as attach. I tested the stepper motors all can turn clockwise and anticlockwise. only when fixed in the board melzi v2 and run repetier host in pronteface manually press +1 it go right -1 not moving. when hold down(not releaseby kkwong1951 - Controllers
hello euxvis, I have installed arduino and merlin and found the configuration.h. what can I do next? Is that the correct step! 1) run merlin 2) select tool--> board-->arduino mega atmega 1284(my board reprap melzi v2 1284p from china) 3)connect use cable to the 3dprinter board 4) load the configuration.h---> change the baurate to 115000 5) press upload please confiby kkwong1951 - Controllers
how to change the melzi v2 atmega1284p setting (upload frimware)? I have installed arduno 1.0.5-r2 but I don't know where to start first. How do I write configuration.h ? where to find the setting. the melzi board(attach photo) got one reset near the chip. do i need to reset first? I want to change the setting because: My 3d printer use repetier host v1.61. I click the arrow it go right but neverby kkwong1951 - Controllers
1 bought 1 prepap i3 with melzi v1.1. after 1 year not working no led light on. I bought a new melzi v2 1284p diy. after installed i test x, y,z end stop: x can go right but not left: y ok:z press 1mm up it go about 10mm up.when press down it down and hit the bed non stop. I send m119 result:x,y,z_min:trigger. I manually move the head to hit the x ,y,z microswitch, I press home all the head moveby kkwong1951 - General