Hi, Im using a Mendelmax with Marlin Firmware (Azteeg X3 Board) and the Repetier Host. I started using slicing with Cura engine and I have the following problem. I set the extruder to home position using the manual control and set it to 0 (numbers in the manual control screen are black). then the printer starts heating up and starts to print.... but about 4cm over the bed! I traced it back toby tsaG - Repetier
Hi, Im using two big motors (2,5A each) on my X-Axis. So, is it possible to connect two Stepperdrivers in parallel? I already soldered it but Im to afraid to test it since I only got one spare Driver What did I do? I connected all Digital pins parallel, cut of the Motor outputs a litle bit and soldered it directly to the PCB regards Patrickby tsaG - Controllers
Hi! I own a CNC mill which I would like to convert into an 3D Printer. My goal is to achieve a high precision printer for 0.0x mm person, would that be possible? What do I need? I found this dual extruder on the net, which looks pretty reliable. My CNC Mill (High-Z-S-400) already has Endstops, so all I need (as I know) is the extruder and the controller, am I right? Which controller should Iby tsaG - CNC Routers, Mills, and Hybrid RepRapping