Hello Buback, Thanks a ton, let me go through the attached, a special thanks again, for immediate reply. PPby pingnagan - Mechanics
thanks a ton Buback, All that Im wondering now, is should someone mention the mechanism as XY kinematics in firmware, so that it would improve the stability and the motion of the Axis.by pingnagan - Mechanics
So how does this XY core mechanism understands the Z height, Im really new on designing these printers, If im blank, please bear with me. XY will have the extruder movements associated simultaneously with both the direction, where the base plate remains constant- Does this not affect the speed of the printing. Throw some light Regards PPby pingnagan - Mechanics
Sure, Ok, If Im not wrong, there could be many new commers just like me. These may be the assumptions that I can take granted 1) There is no difference really in moving any direction, as long as you define the Zero by end stops( rather homing). 2) Calibration is something varies depending upon the tooth that your pulley and the threads that you choose. Can I have the real way of XY core mechanby pingnagan - Reprappers
Thanks Buback, Thats where, I would need some guidance, the syntax on the Firmware, either its only parameter's or some level of coding is essential. Can you suggest some good knowledgebase on this.by pingnagan - Reprappers
Can anyone help me in knwoing the fact of determinning the height factor with the Software or firmware.by pingnagan - Reprappers
thanks pal, i will certainly look that. How does the Z axis works in the XY core mechanism, Im little concerned or would like to know how the height of the object is determined.by pingnagan - Mechanics
Thanks pal, one more question , please bear with me, if its silly. How does the height of the object is determined, since that the parameter controlled by the Z axis, Im sure either grow up or go down could be achieved via stepper motor turns. This really kills my brian, also im little concerned about this and the actual difference with XY-core mechanism. If this is okay, then in XY core mechanby pingnagan - Reprappers
Thanks lazzymonk(but ur not) you mean the End stops correspond where to start and the hoem axis will do that, im bit worried that If the Software assumes moving the Z axis turns, while the mechanism is moving the Z Axis in opposite direction. Hope Im clear on what Im trying to clarify. I know this room is full of experts. It would be great if I have some better way to have a Designing documentatby pingnagan - Reprappers
Thanks dale, while this very generic, can I have some way to learn better in corresponding to PRUSA or other know models here, I know this room is full of experts in some or other way, Where would be the best start point to learn or have some documentation. Thanks in advance.there is so plenty of info, equally anyone could get lost.by pingnagan - Mechanics
How does the Gcode and Software understands the change, we can simple do it, while the same needs to be interpreted in the software aswell.by pingnagan - Reprappers
Dear All Reprappers, I have been trying hard to know the facts of designing a 3D printer. I have few basic queries, rather I need to be clarified. 1) How the Z Axis movement is controlled via the Firmware, For Eg I have my Printer Connected to Threaded Rods and moving the whole X Plane in Upper direction for Increasing the height of the Printed Object. I would need to make the following chanby pingnagan - Mechanics
Dear All Reprappers, I have been trying hard to know the facts of designing a 3D printer. I have few basic queries, rather I need to be clarified. 1) How the Z Axis movement is controlled via the Firmware, For Eg I have my Printer Connected to Threaded Rods and moving the whole X Plane in Upper direction for Increasing the height of the Printed Object. I would need to make the following chanby pingnagan - Reprappers