Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 7 of 7
Hello,
I am trying to print some very large parts with Taulman Nylon Bridge for a customer. These parts are around 12" x 8" x 2" thick. I cannot seem to get rid of warping though. I am fairly new to using Nylon.
I run a Hexagon hot end at 245 C, heated bed at 110 C using Elmers glue stick on a glass print surface. I have an enclosure, that's gets to around 35 C ambient due to the bed heat. I ha
by
MrRocketman
-
Printing
An update on my hollow filament. Protoparadigm is going to send me new spools when they get their in house filament line up and running! Very happy to have good support from Protoparadigm.
by
MrRocketman
-
Printing
Late to the thread but FWIW I just had 3mm ABS Protoparadigm filament with bubbles/hollow bits in it.
Pretty disappointed.
by
MrRocketman
-
Printing
Tried adding caps, decreasing power for LCD backlight, checked all connections a million times... Nothing. So I cut my ribbon cables down from 1m to 0.5m. Haven had a problem since.
by
MrRocketman
-
Firmware - mainstream and related support
Hmm, well mine happens more often than that. I'm going to try adding a capacitor on the 5v line and see if that helps at all. I'll report back if I find any improvements.
by
MrRocketman
-
Firmware - mainstream and related support