Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 12 of 12
I wish I knew of groups meeting in our area.
I desperately need help in my Prusa Mendel 3d printer. Can't seem to get past moving the Axis's correctly.
Using a Gen6 board and the latest Marlin Firmware.
Let me know if you hear of anyone meeting in the Charlotte area.
Regards,
Ken
by
km28104
-
North Carolina RepRap User Group
This appears to be a problem with the Marlin Firmware. I tried editing & compiling the sprinter firmware and had no problems.
What could I be doing wrong?
Ken
by
km28104
-
Firmware - mainstream and related support
Need help with diagnosing a problem with my new gen6 board with latest version of Marlin.
Getting compile errors when trying to change and compile the configuration.H file.
Anyone in NC available for help?
Also building a RoStock Max 3d printer
Ken
by
km28104
-
North Carolina RepRap User Group
Using Arduino v22
New Gen6 board
made minor changes in Config.h and got the following errors:
temperature.cpp:728:1: error: invalid suffix "_WPORT" on integer constant
temperature.cpp:728:1: error: pasting "DIO" and "-" does not give a valid preprocessing token
temperature.cpp:728:1: error: invalid suffix "_PIN" on integer constant
temperature.cpp:728:1: error: pasting "DIO" and "-" does not gi
by
km28104
-
Firmware - mainstream and related support
Ok, made the changes you suggested and was able to see the endstops disabled.
Still motors were not acting right.
Motors moving in the right direction, + direction away from endstops.
Could move motors in the + direction several steps, but would only move in the minus direction the same number of steps and move no further.
Looking more like a problem with the Gen6 board...
Ken
by
km28104
-
Firmware - mainstream and related support
Initially I did not upload the firmware after making changes to configuration.h but have done so since and still the same results.
The opto endstops are keyed so they can only go on the controller one way.
Is there a way to eliminate the end stops to test the direction of movement in all three axixes? I feel that if the axises do move in both directions without being affected by endstops, then
by
km28104
-
Firmware - mainstream and related support
I've recently uploaded the latest version of Marlin FW to replace the sprinter FW on my Prusa Mendel 3d printer
using gen 6 electronics with opto end stops.
Neither FW would move the axises in the correct directions when using pronterface. Jogging in the plus direction on each axis moves axises towards the endstop - direction. Can't move them in the plus direction at all.
I've tried making cha
by
km28104
-
Firmware - mainstream and related support
Wow, not much activity on this forum.
I'm currently finishing a Mendel build using Gen 6 electronics and Lulzbot hot end.
haven't printed anything yet, but close.
Ken
by
km28104
-
North Carolina RepRap User Group
I'm in the process of building my Prusa Mendel and found I need a source for the bronze bushings for the ABS bushing holders.
Does anyone have a part number or source for these?
My 3d printer is Metric.
Thanks,
Ken
by
km28104
-
Reprappers