Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 4 of 4
Hey everyone, thanks for the help.
Went over the back of the board with some more solder and reloaded the firmware, everything seems to be alright now.
Thankyou
by
turbomonkey
-
Reprappers
Tried the switch change and read the m119 statements, doesn't seem to be giving wrong or varying readings. The axis worked after pressing the reset switch then not again. Occasionally get a tiny bit of life out of it, also tried wiring a resistor with the endstop, doesn't really have any affect.
The axis, when it seems to work is after 'warming up' for a bit, do these chips have a booting time?
by
turbomonkey
-
Reprappers
Hey everyone,
I'm a newbie building a Prusa Mendel and have come into a bit of a problem.
My X axis will work, but only intermittently and sometimes in one direction only.
I use the pronterface module with sanguinololu electronics and sprinter firmware (set to board 62) to move the axis about, it will slightly more often move when I key g28, but not very often if I use the keys or type "g1 x5"
by
turbomonkey
-
Reprappers